An electric golf cart jerks when it accelerates. What causes this problem? The most likely cause is that the springs have lost their elasticity. To resolve the problem, you should check the MCOR located under the passenger’s floor board. Ensure that the jumper wire is connected to the accelerator pedal. The MCOR can be accessed via the manual. Once the springs have been replaced, the golf cart should run smoothly.
If your electric golf cart jerks when accelerated, you’ll want to check the solenoid first. If you don’t hear any clicks when you press the accelerator, the solenoid may be the cause. If it is, you can test the solenoid by checking the voltage of the battery and then pressing the accelerator. If you don’t hear any click, this means there is no electricity flowing to the controller. If the jerks are still present, you’ll need to replace the solenoid.
Another common cause of a jerking electrical cart is water damage. A common location for water damage is under the driver’s side floor mat, under the sensor and micro-switch. This can lead to a jerking action when riding, accelerating, and starting the cart. To repair the problem, you’ll need to remove the contaminated part and clean the area thoroughly. During the cleaning process, you can also remove any soiled or corroded parts to see if the problem persists.
If you have noticed that your electric golf cart jerks when accelerated, you’ll need to look into the underlying cause of the problem. This is more likely to happen with older 36V golf cars that don’t have a speed controller, so you’ll need to get it repaired by a mechanic. But if this doesn’t fix the problem, you’ll have to get it repaired.
If you’re experiencing a jerking electrical cart, you should check the voltage of the battery. It should be close to the stated voltage of the battery. If the voltage is lower, then it’s most likely that the battery has low water levels. If the voltage is too high, the solenoid could be malfunctioning. If you’re experiencing a jerking sensation when accelerating, it’s likely that the battery has too much water.
If the problem occurs while accelerating, the cause is unlikely to be the battery. A faulty battery will spark or arc and cause a jerking electric golf cart to stall. Nevertheless, if you’ve gotten a faulty battery, you should take it to a mechanic. If the jerking is caused by the battery, it’s most likely due to a defective or corroded MCOR or clutch.
When your electric golf cart jerks when advancing, it may be due to a faulty solenoid. A faulty solenoid can result in a jerking electrical cart. To fix this issue, you should contact a licensed electrician. The faulty solenoid will need to be replaced. If the symptom persists, it’s best to contact your local golf cart repair professional for further assistance.
A faulty battery could be causing a jerking electrical cart. It can be a faulty battery, or it may be a faulty solenoid. If the solenoid is faulty, it can spark and ignite. It can also be due to a corroded battery connection. It prevents the proper amount of current from flowing to the motor. In both cases, the jerking and swaying will continue until you reach a stop.
If the jerking electric cart continues to jerk even when you are not pressing the accelerator, it may be suffering from water damage. If the driver’s side floor mat is soaked in water, the micro-switch or sensor may have been damaged. The result is a jerking electric cart that can’t move. In these cases, it’s best to replace the battery, which will solve the problem.
A faulty solenoid can also cause a jerking electric golf cart. This can be caused by a faulty clutch, a faulty motor controller, or a faulty adaptor. The speed controller is a crucial component that controls the movement of the cart. A faulty solenoid will cause the cart to jerk when it tries to accelerate. If the speed controller is malfunctioning, it will be impossible to accelerate at a desired rate.